Ok.

At 1 atm. you can not create plasma - to small breakdown voltage (rise it and you will have arc). Pressure goes down, voltage is fixed, and when you reach breakdown voltage you get your glow ( the Townsend discharge happens just as glow discharge becomes visible)-normal glow discharge.

You reduce your pressure more, less and less gas moleucles can be ionized by free electron flow, so the intesity of glow is going down, and finaly it stops, because the breakdown voltage increased and overcome your applied voltage. (see Paschen Curve)

At 1 atm. it is difficult create stable plasma, because breakdown voltage is very high. Your electrodes are located at least 10-15 cm I think, and it is simply you do not have enough electrical potential between them to create initial plasma channel.

Then pressure goes down, voltage is fixed. When you reach breakdown voltage you get your glow (the Townsend discharge happens just as glow discharge becomes visible)-normal glow discharge. What happens? You ionized your gas, you have free electrons and ions, which are floating in different directions: ions are floating to negatively charged cathode and electrons flow to positively charged anode.

Because charge carriers are moving in space. They are rubbing against each other, part of the energy is dissipated and goes into heat and other is emitted and you see your glow. Ions are moving relatively slow, electrons, on contrary, move very fast comparing to ions, because they are light weighted. So this fast free electrons, accelerated by a sufficiently strong electric field, give rise to electrical conduction through a gas by avalanche multiplication caused by the ionization of molecules by ion impact.

Then you continue to reduce your pressure more and more, less and less gas molecules can be ionized by free electron flow, less and les collisions are happening (less energy is dissipated), so the intensity of glow is going down, and finally it stops, because the breakdown voltage increased and overcome your applied voltage. (see Paschen Curve, lower is a pressure higher is the breakdown voltage.)

This is generally how it works.

Please first see this http://en.wikipedia.org/wiki/Gas-filled_tube.

The gas pressure influences the following factors:

• breakdown voltage
• current density
• operating voltage
• backfire voltage
• tube lifetime (lower pressure tubes tend to have shorter lifetimes due to using up of the gas)
• cathode sputtering, reduced at higher pressures

And then try to add additional information about your tube. What is the gas you are using? What is the voltage? And other useful information.

Ok.

At 1 atm. you can not create plasma - to small breakdown voltage (rise it and you will have arc). Pressure goes down, voltage is fixed, and when you reach breakdown voltage you get your glow ( the Townsend discharge happens just as glow discharge becomes visible)-normal glow discharge.

You reduce your pressure more, less and less gas moleucles can be ionized by free electron flow, so the intesity of glow is going down, and finaly it stops, because the breakdown voltage increased and overcome your applied voltage. (see Paschen Curve)