7
$\begingroup$

Looking at this equation $\mathrm{pH} = \mathrm{p}K_\text{a} +\log\frac{[\ce{CB}]}{[\ce{A}]}$ makes me think that it is concentration independent.

What I mean is, when we look at $\frac{[\ce{CB}]}{[\ce{A}]}$, the volumes cancels out, so we are only left with the molar ratio of the conjugate acid and conjugate base. So does this mean that the pH is only dependent on the molar ratios? Obviously not, because $0.003\ \mathrm{mol/L}$ of acid $\ce{A}$ and $0.003\ \mathrm{mol/L}$ of its conjugate base is going to have a different $\mathrm{pH}$ from $0.3\ \mathrm{mol/L}$ of acid $\ce{A}$ and $0.3\ \mathrm{mol/L}$ of its conjugate base right?

What am I missing here? This is seriously confusing me. Please help, I want to use the Henderson–Hasselbalch equation to calculate the $\mathrm{pH}$ of a weak acid as it’s being titrated with a strong base, but this is making me reluctant about the results.

$\endgroup$
6
$\begingroup$

For a much shorter and clearer explanation of this problem, look here.

The Henderson-Hasselbalch (HH) equation is not to blame here. It is an approximate equation, with a certain region of validity. By its nature, it does not take into account the self-dissociation of water, which becomes increasingly important in dilute solutions. When concentrations reach somewhere around $10^{-5}\ mol\ L^{-1}$ or lower, the true $pH$ will deviate significantly from the value predicted by the HH equation. However, this is not the problem most of the time.

The reason the HH equation might produce poor predictions when calculating buffer $pH$ is really because of an oft-made assumption which has nothing to do with the HH equation itself: the weak acid (or weak base) is assumed to be so weak that its ionization contributes almost no conjugate base (or conjugate acid) in comparison to the dissolution of the buffer salt. In other words, we assume the formal concentrations $C_X$ of species in the buffer are equal to their actual concentrations $[X]$; we replace $pH=pK_a+log\ \frac{[A^{-}]}{[HA]}$ for the worse approximation $pH=pK_a+log\ \frac{C_{A^-}}{C_{HA}}$.

This assumption is incorrect, but it is used to make the $pH$ calculation much easier at the cost of accuracy. The resulting approximation breaks down in sufficiently dilute solution, and is already quite noticeable far before reaching water self-dissociation issues. It is also a noticeably poor approximation for weak acids/bases with relatively high ionization constants (say, $K>10^{-2}$).

So how can we visualize the effect of diluting a buffer without approximations, and where do the approximations start to break down? Let us consider the simple case of solutions of a weak monoprotic acid $\ce{HA}$ with acid dissociation constant $K_a$ where the concentration of acid and conjugate base are formally equal. This can be done by titrating half of the weak acid with a strong monoprotic base (e.g. $\ce{KOH}$). This problem can be solved exactly (assuming all activity coefficients are equal to 1, which is generally a good approximation for solutions below about $1\ mol\ L^{-1}$), and I have previously outlined the solution here. The equation relevant to this problem is the following:

$$[H^+]^3+(K_a+\frac{C^o_BV_B}{V_A+V_B})[H^+]^2+(\frac{C^o_BV_B}{V_A+V_B}K_a-\frac{C^o_AV_A}{V_A+V_B}K_a-k_w)[H^+]-K_ak_w=0$$

$V_A$ is the volume of the weak acid solution being titrated and $C^o_A$ is its formal initial concentration (before mixing and reacting with the base), while $V_B$ is a variable volume of strong base solution added with formal initial concentration $C^o_B$ (before mixing and reacting with the acid). The presence of the self-dissociation constant of water $k_w$ shows that it is being taken into consideration.

We can now substitute values as desired to obtain a polynomial in $[H^+]$. I'll set up the volumes and concentrations arbitrarily so we can reach the acid and conjugate base formal concentrations of $0.3\ mol\ L^{-1}$ as mentioned in the question. We can start off with $100\ mL$ of weak acid solution at a concentration of $0.9\ mol\ L^{-1}$ with a dissociation constant $K_a=10^{-3}$ (this constant can be changed at will). We can reach the target concentrations of acid and conjugate base by adding $50\ mL$ of strong base at the same concentration $0.9\ mol\ L^{-1}$ (neutralizing half the original acid). You can check the resulting concentrations after mixing the solutions, if you wish. Solving this polynomial, the resulting buffer solution containing formal concentrations $C_{HA}=0.3\ mol\ L^{-1}$ and $C_{A^{-}}=0.3\ mol\ L^{-1}$ has $[H^+]=9.93399\times 10^{-4}\ mol\ L^{-1}$. This results in $pH=3.00288$, which is very close to the value predicted by the approximations made at the start ($pH=pK_a+log\ 1=pK_a=3$). For now, they work.

After looking at this first case, we shall investigate the effects of dilution by factors of 10. This can be performed simply by diluting both the initial weak acid and strong base concentrations by 10 (i.e., $100\ mL$ of $0.09\ mol\ L^{-1}$ $\ce{HA}$ plus $50\ mL$ of $0.09\ mol\ L^{-1}$ $\ce{KOH}$ result in a buffer with acid/conjugate base concentrations of $0.03\ mol\ L^{-1}$, and so on). Before going into the calculations, it's quite simple to see an issue with the approximation in the second paragraph. Independent of the level of dilution, so long as the concentration of acid and conjugate base remain equal, then according to the approximation, $pH=pK_a=3$. However, consider the case when starting with a solution of $\ce{HA}$ with initial concentration equal to $9\times 10^{-4}\ mol\ L^{-1}$. This is a weak monoprotic acid, so the initial solution must have $[H^+]<9\times 10^{-4}\ mol\ L^{-1}$ and thus $pH>3$. Clearly it's impossible to add any amount of strong base to this acid and get a buffer solution with $pH=3$! The approximations at the start have broken down at this point.

Now, for the calculations. To get the proton concentration, I replaced every value of 0.9 in the previous Wolfram Alpha link with 0.09, then 0.009, and so on. With the proton concentration determined, I used equations shown in my other linked answer to calculate the actual concentrations $[HA]$ and $[A^{-}]$ for comparison with the formal concentrations $C_{HA}$ and $C_{A^{-}}$. Note that they are almost equal at high concentration, but the error increases quite suddenly at lower concentrations. While the ratio $\frac{C_{A^{-}}}{C_{HA}}$ is always equal to 1, the ratio $\frac{[A^{-}]}{[HA]}$ rockets away.

$$ \small \begin{array}{c|ccc|cc} \hline C_{HA} = C_{A^{-}} \ \ (mol\ L^{-1}) & [HA] \ \ (mol\ L^{-1}) & [A^{-}] \ \ (mol\ L^{-1}) & \frac{[A^{-}]}{[HA]} & [H^+] \ \ (mol\ L^{-1}) & pH \\ \hline 0.3 & 0.29901 & 0.30099 & 1.00664 & 9.93399\times 10^{-4} & 3.00288 \\ 0.03 & 0.029061 & 0.030939 & 1.06464 & 9.39282 \times 10^{-4} & 3.02720 \\ 0.003 & 0.00235421 & 0.0036458 & 1.54858 & 6.45751 \times 10^{-4} & 3.18993\\ 3\times 10^{-4} & 1\times 10^{-4} & 5\times 10^{-4} & 5 & 2 \times 10^{-4} & 3.69897 \\ 3\times 10^{-5} & 1.6539\times 10^{-6} & 5.83461\times 10^{-5} & 35.2778 & 2.83464 \times 10^{-5} & 4.54750 \\ 3\times 10^{-6} & 1.78596\times 10^{-8} & 5.98214\times 10^{-6} & 334.953 & 2.98549×10^{-6} & 5.52498 \\ 3\times 10^{-7} & 1.97992\times 10^{-10} & 5.99802\times 10^{-7} & 3029.42 & 3.30096×10^{-7} & 6.48136 \\ 3\times 10^{-8} & 6.96609\times 10^{-12} & 5.99939\times 10^{-8} & 8612.15 & 1.16115×10^{-7} & 6.93511 \\ 3\times 10^{-9} & 6.09004\times 10^{-13} & 5.99939\times 10^{-9} & 9851.15 & 1.01511×10^{-7} & 6.99349 \\ \hline \end{array} $$

$\endgroup$
  • 1
    $\begingroup$ This has to be one of my worst answers ever. The ideas are right, but the presentation and buildup is terrible. I'm still going to edit this a bit, but I have no real hopes of making it less dense. I apologize for my incompetence. $\endgroup$ – Nicolau Saker Neto May 30 '15 at 23:29
  • $\begingroup$ What incompetence??? This is a brilliant answer! $\endgroup$ – user15489 May 31 '15 at 3:05
  • $\begingroup$ (+1) This is magnificent! If this is one of your "worst answers ever" (!), I need to read a lot of your other answers! $\endgroup$ – Ed V Aug 8 at 1:23
1
$\begingroup$

If you have an aqueous solution of a weak acid and its conjugated base, the $\ce{pH }$ of this solution is given by the Henderson Hasselbalch equation. This equation states clearly that the $\ce{pH }$ is dependent on the ratio of concentrations of the weak acid and its conjugated base.

When you have an equimolar solution of the weak acid and its conjugated base, the $\ce{pH = pK_{a}}$.

(One way to prepare buffer solutions is to mix equimolar solutions of a weak acid and its conjugated base).

$\endgroup$
0
$\begingroup$

Try plugging in 0.3 and 0.003 for each case. Either way $\ce{pH = pK_{a}}$ because the ratio of conjugate base concentration to acid concentration is 1. Therefore, the Henderson-Hasselbalch equation is independent of volume.

$\endgroup$

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.