In organic chemistry lecture we discussed the beginning of the Woodward Hoffmann Rules with a key step of the vitamin B12 synthesis.

(The initial paper from their work can be found here: http://pubs.acs.org/doi/pdf/10.1021/ja01080a054)

Let's first see the forward reaction (the electrocyclic ring closure) as Woodward and Hoffmann found (which goes by disrotatory cyclization; 6 electrons, thermal).

Woodward and Hoffmann

I'm interested in the reverse reaction, the ring opening (6 electrons, and therefore disrotatory:

I'm thinking now about the torquoselectivity of the ring-opening (because in an exercise we had an example with 1-Ethyl-1-ethoxy(EDG)-cyclobut-2-ene).

Is there a rule how to see why the E (E: Electron withdrawing group) is in trans position when I start with the product?


I'm thinking if they are some stereoelectronic effects here which explain the obtained selectivity:

enter image description here

See also: http://pubs.acs.org/doi/abs/10.1021/jo00244a058 (Electronic control of the stereoselectivities of electrocyclic reactions of cyclobutenes against incredible steric odds)

Well here we have a conrotatory ring-opening. I don't know if they are still valid in our 6e case for disrotatory ring-opening of the reaction from W. and H..

  • $\begingroup$ Just to be clear, the reaction shown is the electrocyclic ring closure which goes by disrotatory cyclization (6 electron, thermal). But the reaction you are interested in is the reverse process, correct? $\endgroup$
    – jerepierre
    May 8, 2015 at 21:11
  • $\begingroup$ Are you asking, if I start with the cyclohexadiene on the top-right, why does the E group wind up trans to the chain on the other end of the double bond, in the hexatriene on the top-left? $\endgroup$
    – ron
    May 8, 2015 at 21:13
  • $\begingroup$ Exactly (see update) $\endgroup$
    – laminin
    May 8, 2015 at 21:35

1 Answer 1


No, there is no general orbital symmetry rule for predicting which of the two possible disrotatory motions will be favored. However, by examining steric effects in the two possible transition states we can often make a good guess as to which product will predominate. There are always a few "special cases" like the one you referenced in your post, where with certain substituents under certain conditions certain things will happen. But to my knowledge there is no general rule for this situation.

In the following diagram there are 3 thermal reactions controlled by orbital symmetry (6 pi electrons, therefore disrotatory motion).

enter image description here

The top line shows the symmetry allowed disrotatory closure of trans, trans-1,6-dimethylhexatriene. There are two possible disrotatory motions - either the tops or the bottoms of the p-orbitals on carbons 1 and 6 can move towards each other in a disrotatory fashion. One motion produces the dimethylcyclohexadiene with the two methyl groups above the plane of the screen, the other motion produces the mirror image molecule with the methyl groups below the plane of the screen.

Similarly, cis, cis-1,6-dimethylhexatriene can undergo two disrotatory motions to produce the same two products (Note: the cis, cis isomer will react much slower and probably in lower yield; steric interactions between the methyl groups will disfavor the s-trans conformation about the two single bonds that is required for the ring closure to be able to occur).

The bottom line shows the reverse reaction, thermally converting a cyclohexadiene to a hexatriene. As shown, two possible isomers can be formed. The ratio of these two isomers will depend on steric interactions that develop during the two possible disrotatory motions. In this case, we will primarily obtain the trans, trans isomer; the cis, cis isomer has steric problems in its transition state from the two methyl groups bumping into each other (build a model).

In this last reaction, if we replaced the methyl groups with deuterium, we would obtain a roughly equal mixture of the two possible products, cis, cis- and trans, trans-1,6-dideuteriohexatriene. So again, there is no orbital symmetry "rule" for predicting whether a group would wind up cis or trans on the double bond. But if we examine the steric effects in the two possible disrotatory transition states, we can often make a good guess about which isomer should predominate.

  • $\begingroup$ In order to deal with the specific question I've updated my post. Your answer helped me a lot to remind the basic concepts. For small cycles we mostly consider only Hückel overlap (the methyl groups are syn): I guess a möbius overlap resulting in the two methyl groups in anti relationship is sterically disfavored, isn't it? $\endgroup$
    – laminin
    May 8, 2015 at 22:49
  • 1
    $\begingroup$ "I guess a möbius overlap resulting in the two methyl groups in anti relationship is sterically disfavored, isn't it?" Mobius type overlap occurs during conrotatory motion, when the top of one p orbital overlaps with the bottom of the other p orbital to which it is forming a bond. Conrotatory (Mobius) motion is allowed thermally in 4 pi systems. Disrotatory motion is allowed thermally in 4n+2 pi systems. It is orbital symmetry (not steric factors) that prevent formation the methyls in the anti arrangement in the present 6 pi electron example. $\endgroup$
    – ron
    May 8, 2015 at 22:57
  • $\begingroup$ I really like your question, but I'm not completely happy with my chemical understanding of this reaction. Can we predict from stereoelectronic arguments (by assuming E=COOH) why in the initial question the thermally allowed disotatory ring closure gives this preferedly the above mentioned product (Me and H pointing towards us) and not the one in which the methyl group and hydrogen atom of the newly formed bond are pointing at the back? $\endgroup$
    – laminin
    Jun 13, 2015 at 17:58
  • 1
    $\begingroup$ Yes, at least we could make a good guess. There are 2 possible disrotatory motions. The one that would place the "E" down, has the "E" group and the tertiary hydrogen at the ring juncture approaching each other (sterically preferred). Disrotation to place the "E" up, has the E group and the other rings approaching each other (sterically less preferred). $\endgroup$
    – ron
    Jun 13, 2015 at 18:11

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge that you have read and understand our privacy policy and code of conduct.

Not the answer you're looking for? Browse other questions tagged or ask your own question.